Voice Is Not Recognized

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Voice is not Recognized
- Voice is not Recognized

INSPECTION PROCEDURE

PROCEDURE

1. CHECK NAVIGATION SETTING

(a) Enter the "Voice Settings" screen.





(b) Check that "Voice Recognition Guidance" is not "Off".

OK:

"Voice Recognition Guidance" is not off.

NG -- TURN "Voice Recognition Guidance" ON
OK -- Continue to next step.

2. CHECK MAP DISC

(a) Check that the map disc is not deformed or cracked.





OK:

No deformations or cracks in the map disc.

NG -- REPLACE MAP DISC
OK -- Continue to next step.

3. CHECK MAP DISC

(a) Check for dirt on the map disc surface.





OK:

No dirt is on the map disc surface.

HINT
If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.

NOTICE:
Do not use a conventional record cleaner or antistatic preservative.

NG -- CLEAN MAP DISC
OK -- Continue to next step.

4. CHECK MICROPHONE (OPERATION CHECK)

(a) Enter "Microphone&Voice Recognition Check" (Check Mic & Voice Recognition) Operation Check.





(b) When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

(c) Push the recording switch and perform voice recording.

HINT
* Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
* Voice can be recorded for up to 5 seconds.

(d) Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

OK:

All check results are normal.

Text in Illustration





NG -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures

OK -- REPLACE NAVIGATION RECEIVER ASSEMBLY Removal