Operation CHARM: Car repair manuals for everyone.

Reassembly





EXTERIOR: REAR BUMPER: REASSEMBLY

1. INSTALL REAR BUMPER LOWER COVER

(a) Install the 4 screw grommets.





(b) Engage the 4 clips and install the rear bumper lower cover.





(c) Tighten the 4 screws.

Torque : 3.0 Nm (30 kgf-cm, 27 in-lbf)

2. INSTALL REFLEX REFLECTOR ASSEMBLY LH

(a) Install the reflex reflector with the nut.





Torque : 8.0 Nm (80 kgf-cm, 71 in-lbf)

3. INSTALL REFLEX REFLECTOR ASSEMBLY RH

HINT
Use the same procedure as for the LH side.

4. INSTALL REAR BUMPER PAD LH

(a) Engage the 5 claws and install the rear bumper pad.





(b) Install the 5 retainers.

5. INSTALL REAR BUMPER PAD RH

HINT
Use the same procedure as for the LH side.

6. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Back Sonar)

(a) Temporarily install the ultrasonic sensor retainer to the rear bumper.





Text in Illustration





NOTICE:
* Do not damage the rear bumper with the protrusion when installing the retainer.
* Securely install the ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the rear bumper.

HINT
* When installing the retainer, align the keyhole and protrusion as shown in the illustration.
* Use the same procedure for the remaining parts.

(b) Engage the 2 claws to install the ultrasonic sensor retainer.

HINT
Use the same procedure for the remaining parts.

7. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Back Sonar)

(a) Engage the 2 claws to install the ultrasonic sensor.





NOTICE:
Push the ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.

HINT
Use the same procedure for the remaining parts.

8. INSTALL NO. 8 FLOOR WIRE (w/ Back Sonar)

(a) Engage the 7 clamps and install the floor wire.

(b) Connect the 2 connectors.