Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SEAT POSITION SENSOR: INSTALLATION

1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing Service Precautions.

2. INSTALL SEAT POSITION SENSOR

(a) Check that the ignition switch is turned to OFF.

(b) Check that the negative (-) battery terminal is disconnected.

CAUTION:
After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

(c) Install the seat position sensor with the bolt.





Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)

(d) Check that there is no looseness in the installation parts of the seat position sensor.

(e) Connect the connector to the seat position sensor.

3. INSTALL FRONT SEAT ASSEMBLY LH Installation

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)

5. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

HINT
Some systems need initialization when disconnecting the cable from the negative battery terminal.

6. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.