Installation

SUSPENSION: REAR STABILIZER BAR: INSTALLATION

1. INSTALL REAR STABILIZER BUSH





(a) Install the 2 stabilizer bushes onto the stabilizer bar.

HINT
Install the stabilizer bush onto the outer side of the bush stopper on the stabilizer bar.

2. INSTALL REAR STABILIZER BAR





(a) Install the stabilizer bar and 2 stabilizer bracket covers with the 4 bolts.

Torque : 30 Nm (306 kgf-cm, 22 ft-lbf)

3. INSTALL REAR STABILIZER LINK ASSEMBLY





(a) Install the stabilizer link with the nut.

Torque : 70 Nm (714 kgf-cm, 52 ft-lbf)

HINT
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

(b) Install the 2 No. 1 retainers, 2 cushions and No. 2 retainer.

(c) While holding the stabilizer link with a wrench, install a new nut.





Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)

(d) The installation procedure for the RH side is the same as that for the LH side.

4. INSTALL REAR WHEEL

Torque : 112 Nm (1,137 kgf-cm, 82 ft-lbf)