Inner Rear View Mirror Power Source Circuit

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM: Inner Rear View Mirror Power Source Circuit
- Inner Rear View Mirror Power Source Circuit

DESCRIPTION

This is the power source circuit of the inner rear view mirror assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (INNER MIRROR - BATTERY AND BODY GROUND)

(a) Disconnect the R6 inner rear view mirror assembly connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(d) Reconnect the inner rear view mirror assembly connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Rear View Monitor System