Disassembly

ENGINE HOOD / DOOR: REAR DOOR: DISASSEMBLY

HINT
* Use the same procedure for both RH and LH sides.
* The procedure described below is for the RH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ACCESS PANEL REAR WEATHERSTRIP





(a) Remove the access panel rear weatherstrip.

3. REMOVE LAP BELT OUTER ANCHOR COVER





(a) Disengage the 3 claws and remove the lap belt outer anchor cover.

4. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY





(a) Insert a clip remover between the handle and door trim.

(b) Turn the handle with the clip remover inserted, as shown in the illustration.

(c) Remove the rear door inside handle and snap ring.

5. REMOVE NO. 1 CUP HOLDER





(a) Remove the screw and the No. 1 cup holder.

6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY





(a) Remove the bolt and separate the front seat belt outer (floor side).

(b) Disengage the 9 clips and remove the rear door trim panel.





7. REMOVE NO. 1 DOOR TRIM BRACKET





(a) Remove the 2 screws and remove the No. 1 door trim bracket.

8. REMOVE CENTER PILLAR UPPER GARNISH





(a) Remove the clip.

(b) Remove the 2 screws.

(c) Disengage the 2 clips and remove the center pillar upper garnish.





9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY Removal

10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY Removal

11. REMOVE ACCESS PANEL INSIDE HANDLE SUB-ASSEMBLY





(a) Disconnect the rod.

(b) Remove the 3 bolts, then remove the access panel inside handle.

12. REMOVE ACCESS PANEL UPPER LOCK ASSEMBLY Removal

13. REMOVE ACCESS PANEL LOWER LOCK ASSEMBLY Removal

14. REMOVE ACCESS PANEL LOCK REMOTE CONTROL ASSEMBLY





(a) Disconnect the rod and connector clamp.

(b) Remove the 2 bolts, then remove the access panel lock remote control.

15. REMOVE ACCESS PANEL LOCK CANCEL LEVER ASSEMBLY





(a) Using "Torx" socket wrench T30, remove the 2 screws and remove the access panel lock cancel lever.

16. REMOVE FRONT DOOR COURTESY SWITCH Removal

17. REMOVE ACCESS PANEL LOCK STRIKER PLATE ASSEMBLY





(a) Using "Torx" socket wrench T40, remove the 2 screws and access panel lock striker plate.

18. REMOVE REAR DOOR SERVICE HOLE COVER





(a) Remove the rear door service hole cover.

NOTICE:
Remove any tape remaining on the door side.

19. REMOVE REAR DOOR OPENING TRIM

(a) Remove the rear door opening trim.





20. REMOVE ACCESS PANEL CHECK ASSEMBLY





(a) Remove the bolt and 2 nuts, then remove the access panel check.

NOTICE:
Do not drop or damage the access panel check when removing the bolt and nuts.

HINT
Remove the access panel check through the service hole.

21. REMOVE ACCESS PANEL WEATHERSTRIP





(a) Disengage the 6 clips.

(b) Using a clip remover, disengage the 20 clips, then remove the access panel weatherstrip.





NOTICE:
Remove any tape remaining on the door side.

22. REMOVE ACCESS PANEL LOWER LOCK STOP





(a) Using "Torx" socket wrench T40, remove the 2 screws and access panel lower lock stop.

23. REMOVE ACCESS DOOR OUTSIDE MOULDING SUB-ASSEMBLY

HINT
Use the same procedure as for the LH side Removal.

24. REMOVE ACCESS DOOR GLASS OUTER WEATHERSTRIP

HINT
Use the same procedure as for the LH side Removal.

25. REMOVE REAR DOOR GLASS

HINT
Use the same procedure as for the LH side Removal.