Component Tests and General Diagnostics

LIGHTING: ROOM LIGHT ASSEMBLY (for Rear): INSPECTION

1. INSPECT REAR ROOM LIGHT ASSEMBLY





(a) Check the resistance.

(1) Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

Standard Resistance:





If the result is not as specified, replace the room light.

(b) Check the light operation.

(1) Connect the positive (+) battery lead to terminal B and the negative (-) battery lead to terminal CTY, then check that the light illuminates when the switch is in the DOOR position.

Standard:

Light illuminates.

If the light does not illuminate, replace the bulb.

(2) Connect the positive (+) battery lead to terminal B and the negative (-) battery lead to terminal E, then check that the light illuminates when the switch is in the ON position.

Standard:

Light illuminates.

If the light does not illuminate, replace the bulb.