Installation

A750F AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY





(a) Install the park/neutral position switch onto the manual valve shaft.

(b) Temporarily install the bolt.

(c) Install a new lock washer and the nut.

Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(d) Push the control shaft rearward as much as possible.





(e) Return the control shaft lever 2 notches to the N position.

(f) Align the neutral basic line with the switch groove, and tighten the bolt.





Torque : 13 Nm (129 kgf-cm, 9.4 ft-lbf)

(g) Using a screwdriver, bend the tabs of the lock washer.

2. CONNECT PARK / NEUTRAL POSITION SWITCH CONNECTOR

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)

4. PERFORM INITIALIZATION

Programming and Relearning

5. INSPECT SHIFT LEVER POSITION Adjustments

6. ADJUST SHIFT LEVER POSITION Adjustments

7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY Initial Inspection and Diagnostic Overview