Body - Roof Rack Leg Cover Installation
T-SB-0252-10August 16, 2010
Roof Rack Leg Cover Installation During PDS
Service Category
General
Section
Pre-Delivery Service
Market
USA
Applicability
Introduction
To prevent damage to the roof rack leg cover prior to installation of the crossbars the leg covers are not installed from the factory. Install the roof rack leg covers according to the following procedure during Pre-Delivery Service (PDS). Crossbars should be installed prior to the installation of the roof rack leg covers.
Warranty Information
Installation Procedure
For roof rack crossbar installation follow the installation instructions found on the Technical Information System (TIS).
The roof rack leg covers are stored in the vehicle's cargo area.
1. Install the right and left rear roof rack leg covers in the following sequence (labeled in Figure 1).
A. Insert the tab at the front of the cover into the roof rack rail.
B. Place the cover on the leg and align the rear part of the cover. Do NOT press down.
C. Press the cover claws facing the inside of the vehicle into place.
Do NOT press the claws facing the outside of the vehicle at the same time as pressing the claws facing the inside. The leg cover may be damaged.
D. Press the cover claws facing the outside of the vehicle into place.