Installation

AIR CONDITIONING: COMPRESSOR (for 2GR-FE): INSTALLATION

1. TEMPORARILY TIGHTEN COMPRESSOR AND MAGNETIC CLUTCH

(a) Temporarily install the compressor and magnetic clutch and the bracket with the 2 stud bolts and 2 bolts.





2. INSTALL COMPRESSOR AND MAGNETIC CLUTCH

(a) Install the compressor and magnetic clutch with the 2 bolts and 2 nuts.





Torque : 25 Nm (255 kgf-cm, 18 ft-lbf)

NOTICE:
Tighten the bolts and nuts in the order shown in the illustration to install the compressor and magnetic clutch.

(b) Engage each clamp.

(c) Connect the connector.

3. CONNECT SUCTION HOSE SUB-ASSEMBLY

(a) Remove the attached vinyl tape from the hose.

(b) Apply sufficient compressor oil to a new O-ring and the fitting surface of the compressor and magnetic clutch.

Compressor oil:

ND-OIL 8 or equivalent

(c) Install the O-ring onto the suction hose sub-assembly.

(d) Install the suction hose sub-assembly onto the compressor and magnetic clutch with the bolt.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

4. CONNECT DISCHARGE HOSE SUB-ASSEMBLY

(a) Remove the attached vinyl tape from the hose.

(b) Apply sufficient compressor oil to a new O-ring and the fitting surface of the compressor and magnetic clutch.

Compressor oil:

ND-OIL 8 or equivalent

(c) Install the O-ring onto the discharge hose sub-assembly.

(d) Install the discharge hose sub-assembly onto the compressor and magnetic clutch with the bolt.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

5. INSTALL RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR

Installation

6. INSTALL V-RIBBED BELT

Installation

7. CHARGE WITH REFRIGERANT Service and Repair

8. WARM UP ENGINE Service and Repair

9. INSPECT FOR REFRIGERANT LEAK Service and Repair