Installation

2GR-FE ENGINE CONTROL SYSTEM: HEATED OXYGEN SENSOR: INSTALLATION

1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

(a) Using SST, install the heated oxygen sensor to the front No. 3 exhaust pipe sub-assembly.

SST : 09224-00010

Torque : 40 Nm (408 kgf-cm, 30 ft-lbf) for use with SST

Torque : 44 Nm (449 kgf-cm, 32 ft-lbf) for use without SST

HINT
* Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
* Make sure that SST and the wrench are connected in a straight line.

3. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

4. INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY Installation

5. INSTALL CENTER EXHAUST PIPE ASSEMBLY Installation

6. INSTALL TAIL EXHAUST PIPE ASSEMBLY Installation

7. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) Installation

8. FULLY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) Installation

9. INSPECT FOR EXHAUST GAS LEAK Installation

10. INSPECT AND ADJUST TRANSFER OIL (for 4WD)

HINT

11. INSTALL FRONT FLOOR COVER LH

(a) Install the 3 clamps, 6 bolts and the front floor cover LH.

12. INSTALL NO. 2 ENGINE UNDER COVER Installation

13. INSTALL NO. 1 ENGINE UNDER COVER Installation

14. INSTALL ENGINE UNDER COVER ASSEMBLY Installation