Installation

U151E AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the park/neutral position switch to the manual valve shaft.





(b) Temporarily install the 2 bolts.

(c) Place a new lock plate and tighten the nut.





Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(d) Temporarily install the control shaft lever.

(e) Turn the lever counterclockwise until it stops and then turn it clockwise 2 notches.





(f) Remove the control shaft lever.

(g) Align the groove with the neutral basic line.





(h) Hold the switch in position and tighten the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(i) Using a screwdriver, bend the tabs of the lock plate.





(j) Install the control shaft lever washer and nut.





Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(k) Connect the park/neutral position switch connector.





2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Connect the control cable to the control shaft lever with the nut.





Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(b) Install the control cable to the bracket with a new clip.





3. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY Adjustments

4. ADJUST SHIFT LEVER POSITION Adjustments

5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION On-Vehicle Inspection

6. INSPECT SHIFT LEVER POSITION On-Vehicle Inspection

7. INSTALL AIR CLEANER BRACKET Installation

8. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

9. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

10. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

11. INSTALL NO. 1 AIR CLEANER INLET Installation

12. INSTALL NO. 2 AIR CLEANER INLET Installation

13. INSTALL COOL AIR INTAKE DUCT SEAL Installation

14. INSTALL BATTERY Installation

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.