Installation

2GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.

(b) Install the crankshaft position sensor with the bolt.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(c) Connect the crankshaft position sensor connector.

2. TEMPORARILY TIGHTEN COMPRESSOR AND MAGNETIC CLUTCH Installation

3. INSTALL COMPRESSOR AND MAGNETIC CLUTCH Installation

4. CONNECT SUCTION HOSE SUB-ASSEMBLY Installation

5. CONNECT DISCHARGE HOSE SUB-ASSEMBLY Installation

6. INSTALL RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR Installation

7. INSTALL COOLER CONDENSER ASSEMBLY Installation

8. INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY Installation

9. INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch) Installation

10. INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch) Installation

11. INSTALL RADIATOR GRILLE SUB-ASSEMBLY Installation

12. CONNECT COOLING FAN ECU CONNECTOR Installation

13. CONNECT OIL COOLER HOSE Installation

14. CONNECT NO. 2 RADIATOR HOSE Installation

15. CONNECT NO. 1 RADIATOR HOSE Installation

16. INSTALL NO. 1 AIR CLEANER INLET Installation

17. INSTALL NO. 2 AIR CLEANER INLET Installation

18. INSTALL BATTERY Installation

19. INSTALL COOL AIR INTAKE DUCT SEAL Installation

20. CHARGE WITH REFRIGERANT Service and Repair

21. ADD ENGINE COOLANT Service and Repair

22. INSPECT FOR COOLANT LEAK Testing and Inspection

23. INSPECT AUTOMATIC TRANSAXLE FLUID

HINT


24. INSPECT FOR OIL LEAK

25. WARM UP ENGINE Service and Repair

26. INSPECT FOR REFRIGERANT LEAK Service and Repair

27. INSTALL NO. 1 ENGINE UNDER COVER Installation

28. INSTALL ENGINE UNDER COVER ASSEMBLY Installation

29. INSTALL V-BANK COVER SUB-ASSEMBLY Installation