Removal

2GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: REMOVAL

1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Service and Repair

2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

3. REMOVE ENGINE UNDER COVER ASSEMBLY Removal

4. REMOVE NO. 1 ENGINE UNDER COVER Removal

5. DRAIN ENGINE COOLANT Service and Repair

6. REMOVE COOL AIR INTAKE DUCT SEAL Removal

7. REMOVE BATTERY Removal

8. REMOVE NO. 2 AIR CLEANER INLET Removal

9. REMOVE NO. 1 AIR CLEANER INLET Removal

10. DISCONNECT NO. 1 RADIATOR HOSE Removal

11. DISCONNECT NO. 2 RADIATOR HOSE Removal

12. DISCONNECT OIL COOLER HOSE Removal

13. DISCONNECT COOLING FAN ECU CONNECTOR Removal

14. REMOVE RADIATOR GRILLE SUB-ASSEMBLY Removal

15. REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch) Removal

16. REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch) Removal

17. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY Removal

18. SEPARATE COOLER CONDENSER ASSEMBLY Removal

19. REMOVE RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR Removal

20. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY Removal

21. DISCONNECT SUCTION HOSE SUB-ASSEMBLY Removal

22. REMOVE COMPRESSOR AND MAGNETIC CLUTCH Removal

23. REMOVE CRANKSHAFT POSITION SENSOR

(a) Disconnect the crankshaft position sensor connector.





(b) Remove the bolt and crankshaft position sensor.