Reverse Signal Circuit

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM (w/o Navigation System): Reverse Signal Circuit
- Reverse Signal Circuit

DESCRIPTION

The clock assembly receives a reverse signal from the BK/UP LP relay.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK BACK-UP LIGHT

(a) Move the shift lever to the R position and check if the back-up lights come on.

OK:

The back-up lights come on.

NG -- GO TO LIGHTING SYSTEM Back-Up Light Circuit
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

(a) Disconnect the E11 clock assembly connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Rear View Monitor System (w/o Navigation System)