On-Vehicle inspection

METER: METER / GAUGE SYSTEM: ON-VEHICLE INSPECTION

1. INSPECT SPEEDOMETER

(a) Check the operation.

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON (READY).

(3) Turn the Techstream on.

(4) Enter the following menus: Powertrain / Engine and ECT / Data List.

Reference: mph (for U.S.A.)





Reference: km/h (for Canada)





NOTICE:
Tire wear as well as over or under inflation will cause errors.

(5) Check the deviation from the acceptable range of the speedometer indication.

Reference:

Less than 0.5 km/h (0.3 mph)

HINT
If the indication is not as specified, go to problem symptoms table Problem Symptoms Table.

2. INSPECT MULTI-INFORMATION DISPLAY

(a) Ignition switch off.





(b) Press the "DISP" button and hold it down.

(c) Turn the ignition switch to ON.

OK:

All the dots in the multi-information display come on.

HINT
This test is also available on "Active Test" Meter / Gauge System.

(d) Ignition switch off to finish this test mode.

HINT
If the result is not as specified, replace the clock assembly Removal.