Meter / Gauge System
METER: METER / GAUGE SYSTEM: DATA LIST / ACTIVE TEST
1. Data List
HINT
Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Warm up the engine.
(b) Ignition switch off.
(c) Connect the Techstream to the DLC3.
(d) Turn the ignition switch to ON.
(e) Turn the Techstream on.
(f) Enter the following menus:
(1) for Combination Meter: Body Electrical / Combination Meter / Data List.
(2) for ABS/TRAC/VSC: Chassis / ABS/VSC/TRAC / Data List.
(3) for Hybrid Control: Powertrain / Hybrid Control / Data List.
(g) Check values by referring to the table below.
Combination Meter:
ABS/VSC/TRAC:
Hybrid Control:
2. Active Test
Using Techstream to perform Active Tests allows the relay, actuator, and other items to operate without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Test early in troubleshooting is one way to save diagnostic time. Data List information can be display while performing Active Test.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus:
(1) for Combination Meter: Body Electrical / Combination Meter / Active Test.
(2) for Main Body: Body Electrical / Main Body/ Active Test.
(e) Check the operation by referring to the table below.
Combination Meter:
*1: for U.S.A.
*2: except for U.S.A.
ECB*: Electronically Controlled Brake System
Main Body:
