Installation

HORN: SPIRAL CABLE: INSTALLATION

1. INSTALL SPIRAL CABLE

(a) Engage the 6 claws and 2 pins, and install the spiral cable to the steering angle sensor.





2. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR Installation

3. INSTALL STEERING COLUMN COVER Installation

4. ADJUST SPIRAL CABLE Installation

5. INSTALL STEERING WHEEL ASSEMBLY Installation

6. INSTALL STEERING PAD Installation

7. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

8. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. INSPECT STEERING WHEEL CENTER POINT

11. REMOVE BATTERY SERVICE HOLE COVER ASSEMBLY Installation

12. REMOVE DECK BOARD ASSEMBLY Installation

13. INSPECT STEERING PAD Installation

14. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.