Installation

PARKING BRAKE: PARKING BRAKE SWITCH: INSTALLATION

1. INSTALL PARKING BRAKE SWITCH ASSEMBLY

(a) Install the parking brake switch assembly to the parking brake control pedal assembly with the screw.

Torque : 0.9 Nm (9 kgf-cm, 8 in-lbf)

2. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Temporarily install the parking brake control pedal assembly with the 3 nuts.

(b) Tighten the 3 nuts.

Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

(c) Connect the parking brake switch connector.

3. CONNECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

Installation

4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. INSTALL BATTERY SERVICE HOLE COVER ASSEMBLY Installation

7. INSTALL DECK BOARD ASSEMBLY Installation

8. INSPECT BRAKE WARNING LIGHT Adjustments

9. INSPECT SRS WARNING LIGHT

Diagnosis System