Operation CHARM: Car repair manuals for everyone.

Installation





SUPPLEMENTAL RESTRAINT SYSTEM: SEAT POSITION SENSOR: INSTALLATION

1. INSTALL SEAT POSITION SENSOR

(a) Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.





(b) Using a 1.3 mm (0.051 in.) feeler gauge, temporarily install the seat position sensor.





NOTICE:
* If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
* When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

HINT
Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.024 in.) to 2.0 mm (0.079 in.).

(c) Using a "TORX" socket wrench (T30), tighten the "TORX" screw to install the seat position sensor.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.024 in.) to 2.0 mm (0.079 in.).

(e) Connect the connector.

(f) Check that there are no loose parts after installing the seat position sensor.

2. INSTALL FRONT SEAT ASSEMBLY LH Installation

3. INSTALL REAR INNER SEAT TRACK COVER LH Installation

4. INSTALL REAR OUTER SEAT TRACK COVER LH Installation

5. INSTALL FRONT INNER SEAT TRACK COVER LH Installation

6. INSTALL FRONT OUTER SEAT TRACK COVER LH Installation

7. INSTALL FRONT SEAT HEADREST ASSEMBLY LH Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

9. INSTALL BATTERY SERVICE HOLE COVER ASSEMBLY Installation

10. INSTALL DECK BOARD ASSEMBLY Installation

11. INSPECT FRONT SEAT ASSEMBLY Installation

12. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.