Crankshaft Main Bearing
CRANKSHAFTTighten the crankshaft bearing cap bolts.
The crankshaft bearing cap bolts are tightened in 2 progressive steps.
Step 1:
Uniformly tighten the 16 crankshaft bearing cap bolts in several steps in the sequence shown in the illustration.
Torque 61 Nm (622 kgf-cm, 45 ft-lbf)
If any of the crankshaft bearing cap bolts does not meet the specified torque, replace it.
Step 2:
Mark the front of the bearing cap bolts with paint.
Tighten the bearing cap bolts 90° in the order shown in step 1.
Check that the painted marks are now at a 90° angle to the front.
Install 8 new seal washers and uniformly tighten the 8 crankshaft bearing cap bolts in several steps in the sequence shown in the illustration.
Torque 52 Nm (525 kgf-cm, 38 ft-lbf)
Standard Bolt:
Text in Illustration
MAIN BEARING CLEARANCE, STANDARD & LIMIT
MAIN BEARING SIZE CODES
There are 5 sizes of standard bearings, marked "1", "2", "3", "4" and "5" accordingly.
New Bearing:
Text in Illustration
EXAMPLE: Cylinder block "11" (A) + Crankshaft "06" (B) = Total number 17 (Use bearing "3")
Standard Cylinder Block Main Journal Bore Diameter (A):
Standard Crankshaft Main Journal Diameter (B):
Standard Upper Bearing Center Wall Thickness (No. 1 and No. 4 Journal):
Standard Lower Bearing Center Wall Thickness (No. 1 and No. 4 Journal):
Standard Upper Bearing Center Wall Thickness (No. 2 and No. 3 Journal):
Standard Lower Bearing Center Wall Thickness (No. 2 and No. 3 Journal):
