Window Regulator: Testing and Inspection

WINDSHIELD / WINDOW GLASS: POWER WINDOW REGULATOR MOTOR: INSPECTION

1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side)

(a) Apply battery voltage to the motor connector according to the table below.

NOTICE:
* Do not apply voltage to any terminals except terminals 1 and 2, to avoid damaging the pulse sensor inside the motor.
* Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.





NOTICE:
Do not apply battery voltage to any terminals except terminals 1, 2, 4, 7 and 10.

OK:





If the result is not as specified, replace the regulator motor assembly.

2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Side)

(a) Apply battery voltage to connector terminals 1 and 2.

NOTICE:
Do not apply battery voltage to any terminals except terminals 1 and 2.





(b) Check that the motor gear rotates smoothly as follows.

OK:





If the result is not as specified, replace the regulator motor assembly.

3. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side)

(a) Apply battery voltage to connector terminals 1 and 2.

NOTICE:
Do not apply battery voltage to any terminals except terminals 1 and 2.





(b) Check that the motor gear rotates smoothly as follows.

OK:





If the result is not as specified, replace the regulator motor assembly.

4. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH Side)

(a) Apply battery voltage to connector terminals 1 and 2.

NOTICE:
Do not apply battery voltage to any terminals except terminals 1 and 2.





(b) Check that the motor gear rotates smoothly as follows.

OK:





If the result is not as specified, replace the regulator motor assembly.