Installation

INTERIOR PANELS / TRIM: FRONT CONSOLE BOX (w/ Cool Box): INSTALLATION

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL COOLING BOX ASSEMBLY

(a) Attach the 2 claws.

(b) Connect the connector.

(c) Sufficiently apply compressor oil to 2 new O-rings.

Compressor oil:

ND-OIL 8 or equivalent

(d) Install the 2 O-rings on the 2 cooler pipes.

(e) Connect the 2 cooler pipes with the 2 bolts.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

(f) Install the cooling box with the 4 bolts and 2 screws.

2. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY

(a) Connect the connectors and 2 clamps.

(b) Attach the 8 claws to install the end panel.

3. INSTALL NO. 1 COOLER COVER

(a) Attach the claw on the upper part of the cooler cover, and then attach the clamp on the lower part of the cooler cover to install it.

4. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

(a) Connect the connectors.

(b) Attach the 14 claws to install the console panel.

5. INSTALL CONSOLE CUP HOLDER BOX SUB-ASSEMBLY

(a) Attach the 4 claws to install the box.

6. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

(a) Attach the 9 claws to install the panel.

7. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

(a) Connect the connectors.

(b) Attach the 7 claws to install the panel.

8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

(a) Install the shift lever knob and twist it in the direction indicated by the arrow.

9. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

(a) Attach the 7 claws to install the panel pad.

(b) Install the screw.

(c) Install the clip.

10. INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION

(a) Attach the 7 claws to install the panel cushion.

11. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

(a) Connect the connectors and 2 clamps.

(b) Attach the 8 claws to install the panel pad.

(c) Install the screw.

(d) Install the clip.

12. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

(a) Attach the 7 claws to install the panel cushion.

13. INSTALL FRONT SEAT ASSEMBLY LH

(a) Install the front seat assembly LH Installation.

14. CHARGE REFRIGERANT Service and Repair

15. WARM UP ENGINE Service and Repair

16. CHECK FOR REFRIGERANT GAS LEAK Service and Repair