Road Test

CRUISE CONTROL: CRUISE CONTROL SYSTEM: ROAD TEST

1. PROBLEM SYMPTOM CONFIRMATION

(a) Inspect the SET function.





(1) Turn the main switch on.

(2) Drive at the required speed (40 km/h (25 mph) or more).

(3) Push the cruise control main switch to -SET.

(4) After releasing the switch, check that the vehicle cruises at the set speed.

(b) Inspect the + (ACCELERATION) function.





(1) Turn the main switch on.

(2) Drive at the required speed (40 km/h (25 mph) or more).

(3) Push the cruise control main switch to -SET.

(4) Check that the vehicle speed increases while the cruise control main switch is pushed to +RES, and that the vehicle cruises at the newly set speed when the switch is released.

(5) Momentarily push the cruise control main switch to +RES and then immediately release it. Check that the vehicle speed increases by approximately 1.6 km/h (1.0 mph) (tap-up control).

(c) Inspect the - (COAST) function.





(1) Turn the main switch on.

(2) Drive at the required speed (40 km/h (25 mph) or more).

(3) Push the cruise control main switch to -SET.

(4) Check that the vehicle speed decreases while the cruise control main switch is pushed to -SET, and that the vehicle cruises at the newly set speed when the switch is released.

(5) Momentarily push the cruise control main switch to -SET, and then immediately release it. Check that vehicle speed decreases by approximately 1.6 km/h (1.0 mph) (tap-down control).

(d) Inspect the CANCEL function.





(1) Turn the main switch on.

(2) Drive at the required speed (40 km/h (25 mph) or more).

(3) Push the cruise control main switch to -SET.

(4) When performing one of the following, check that the cruise control system is canceled and that the normal driving mode is reset.

* Depressing the brake pedal.

* Moving the shift lever from D to N.

* With the shift lever in S, selecting the S1, S2 or S3 range.

* Turning the main switch off.

* Pulling the cruise control main switch to CANCEL.

(e) Inspect the RES (RESUME) function.





(1) Turn the main switch on.

(2) Drive at the required speed (40 km/h (25 mph) or more).

(3) Push the cruise control main switch to -SET.

(4) Cancel the cruise control system according to any of the above operations (other than turning the main switch off).

(5) After pushing the cruise control main switch to +RES at a driving speed of more than 40 km/h (25 mph), check that the vehicle drives at the set speed.