Part 2

NETWORKING: CAN COMMUNICATION SYSTEM: TERMINALS OF ECU - Continued

11. CHECK DISPLAY AND NAVIGATION MODULE DISPLAY

HINT
For vehicles with the navigation system only.





(a) Disconnect the F47 display and navigation module display connector.

(b) Measure the resistance according to the value(s) in the table below.





12. CHECK STEERING ANGLE SENSOR





(a) Disconnect the E11 sensor connector.

(b) Measure the resistance according to the value(s) in the table below.





13. CHECK YAW RATE SENSOR





(a) Disconnect the E50 sensor connector.

(b) Measure the resistance according to the value(s) in the table below.





14. CHECK SEAT BELT CONTROL ECU

HINT
For vehicles with the pre-collision system only.





(a) Disconnect the E41 and E42 ECU connectors.

(b) Measure the resistance according to the value(s) in the table below.





15. CHECK CLEARANCE WARNING ECU

HINT
For vehicles with the intuitive parking assist system only.





(a) Disconnect the F12 ECU connector.

(b) Measure the resistance according to the value(s) in the table below.





16. CHECK OUTER MIRROR CONTROL ECU





(a) Disconnect the I17 and I18 ECU connectors.

(b) Measure the resistance according to the value(s) in the table below.





17. CHECK MULTIPLEX TILT AND TELESCOPIC ECU





(a) Disconnect the E27 ECU connector.

(b) Measure the resistance according to the value(s) in the table below.





18. CHECK CERTIFICATION ECU (SMART KEY ECU)





(a) Disconnect the E29 ECU connector.

(b) Measure the resistance according to the value(s) in the table below.





19. CHECK POSITION CONTROL ECU AND SWITCH





(a) Disconnect the c14 and c15 ECU connectors.

(b) Measure the resistance according to the value(s) in the table below.





20. CHECK TIRE PRESSURE WARNING ECU

HINT
For vehicles with the tire pressure warning system only.





(a) Disconnect the L10 connector.

(b) Measure the resistance according to the value(s) in the table below.





21. CHECK 4WD CONTROL ECU





(a) Disconnect the A27 and A28 ECU connectors.

(b) Measure the resistance according to the value(s) in the table below.





22. CHECK NETWORK GATEWAY ECU





(a) Disconnect the E31 ECU connector.

(b) Measure the resistance according to the value(s) in the table below.





* *1: For V bus

* *2: For movement control bus

23. CHECK WINDSHIELD WIPER ECU

HINT
For vehicles with the tire rain sensor only.





(a) Disconnect the E85 ECU connector.

(b) Measure the resistance according to the value(s) in the table below.