Operation Check
DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM: OPERATION CHECK
1. CHECK ELECTRICAL DOOR LOCK OPERATION
NOTICE:
The operation check below is based on the non-customized initial condition of the vehicle Programming and Relearning.
(a) Check the basic function.
(1) Check that all doors lock when the door control switch (for manual operation) is pushed to LOCK and all doors unlock when pushed to UNLOCK.
(2) Check that all doors lock when the driver side door lock key cylinder is turned to LOCK using the mechanical key.
(b) Check the key lock-in prevention function.
NOTICE:
In order to prevent the key from being actually locked-in, the inspection should be performed with the driver side door window open.
(1) Have the key inserted into the ignition key cylinder.
(2) With the driver side door open, check that all doors unlock immediately after the door lock knob for the driver side door is turned to LOCK.
(3) With the driver side door open, check that all doors unlock immediately after the door control switch (for manual operation) is turned to LOCK.
(4) With the driver side door open, turn the driver side door lock knob to LOCK, and then close the driver side door. Then check that all doors unlock.
(c) Check the security function.
(1) Close all doors with the driver side door window open so that the door control switch can be operated from outside the vehicle.
(2) Pull out the mechanical key (transmitter), open the driver side door and then close and lock the door using the mechanical key (transmitter). Under this condition, check that all doors do not unlock when the door control switch (for manual operation) is turned to UNLOCK from outside the vehicle.
(3) Pull out the mechanical key, and close and lock the driver side door using the mechanical key. Under this condition, check that all doors do not unlock when the door control switch (for manual operation) is turned to UNLOCK from outside the vehicle.
(4) Pull out the mechanical key (transmitter), close the driver side door, and lock the door by wireless door lock operation. Under this condition, check that all doors do not unlock when the door control switch (for manual operation) is turned to UNLOCK from outside the vehicle.
HINT
Check that the security function is canceled under the following conditions:
* The ignition switch to ON.
* The driver side door is unlocked using the mechanical key (transmitter).
(d) Check the illumination function.
(1) Set the room light switch to the DOOR position.
(2) With all doors locked, check that the driver's door unlocks when the driver side door lock cylinder is turned to UNLOCK using the key. At the same time, the room light comes on.
(3) Check that the room light goes off in approximately 15 seconds if the doors have not been opened.
(e) Check the key-linked 2-step unlock function.
(1) Lock all doors.
(2) Check that only the driver side door unlocks when the driver side door lock cylinder is turned to UNLOCK once using the key and other doors unlock when turned to UNLOCK consecutively once again.
(f) Check the speed-sensitive automatic door lock function.
(1) When a door is unlocked and the vehicle is driven at approximately 20 km/h (13 mph) or more, check that all doors automatically lock a total of 2 times (automatic door lock).
(g) Check the shift-linked automatic door unlock function
(1) Check that all doors unlock automatically when the shift lever is moved to P from any position other than P.