How To Proceed With Troubleshooting

CRUISE CONTROL: DYNAMIC LASER CRUISE CONTROL SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

HINT
* Use these procedures to troubleshoot the dynamic radar cruise control system.
* *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. INSPECT BATTERY VOLTAGE

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, replace or recharge the battery before proceeding.

NEXT -- Continue to next step.

3. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)*

(a) Use the Techstream to check for normal function of CAN communication system.

(1) Perform bus check (communication malfunction DTC).

(2) Perform bus check (communication bus check).

Result





B -- GO TO CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

4. CHECK FOR DTC*

Refer to DTC Check/Clear Dynamic Laser Cruise Control System.

(a) Check for DTC and note any codes that are output.

(b) Clear the DTC.

(c) Recheck for DTC. Try to prompt the DTC by simulating the original activity that the DTC suggests.

Result





B -- Go to step 7
A -- Continue to next step.

5. PROBLEM SYMPTOMS TABLE

Refer to the Problem Symptoms Table Dynamic Laser Cruise Control System.

Result





B -- Go to step 7
A -- Continue to next step.

6. OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Terminals of ECU Dynamic Laser Cruise Control System.

(b) Data List/Active Test Dynamic Laser Cruise Control System.

NEXT -- Continue to next step.

7. ADJUST, REPAIR OR REPLACE

NOTICE:
* When the distance control ECU is replaced with a new one, initialization must be performed Programming and Relearning.
* When the radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed Laser Sensor.

NEXT -- Continue to next step.

8. CONFIRMATION TEST

NEXT -- END