Programming and Relearning

CRUISE CONTROL: DYNAMIC LASER CRUISE CONTROL SYSTEM: INITIALIZATION

1. INITIALIZE DISTANCE CONTROL ECU

NOTICE:
After replacing the distance control ECU and engine ECM, it is necessary to initialize the distance control ECU so that the ECU can recognize the specification of the vehicle.

(a) Perform the following procedures after replacing the distance control ECU.

(1) Turn the ignition switch to ON.

(2) Turn the cruise main switch on.

(3) With the brake pedal depressed, push the cruise control main switch to RES/ACC 3 times within 3 seconds. Check that the buzzer sounds at this time.

NOTICE:
Do not turn the headlight dimmer switch on at this time because the optical axis automatic adjustment mode has already started, which may lead to an incorrect optical axis setting. If the headlight dimmer switch is turned on by mistake, readjust the optical axis Laser Sensor.