Removal

1UR-FE ENGINE CONTROL: ECM: REMOVAL

1. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

2. REMOVE AIR CLEANER ASSEMBLY Removal

3. DISCONNECT WATER PIPE ASSEMBLY

(a) Remove the 2 nuts and disconnect the water pipe.





4. DISCONNECT CONNECTOR HOLDER BLOCK

(a) Remove the connector holder block cover.

(b) Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.





5. REMOVE ECM

(a) Disconnect the wire harness clamp.





(b) Raise the 2 levers while pushing the locks on the 2 levers shown in the illustration.





NOTICE:
Make sure that the lock lever is raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.

(c) Disconnect the 2 connectors.

(d) Remove the 4 bolts and ECM.





6. REMOVE GASKET

(a) Peel off the rubber part of the gasket.





(b) Spray gasket remover or equivalent on the remaining tape of the gasket.





NOTICE:
When using gasket remover or equivalent, cover the ECM connector with a cloth.

(c) Remove the tape of the gasket without using bladed objects.