Engine Controls - Non-Linear Acceleration From A Stop
T-SB-0295-10November 1, 2010
Non-Linear Acceleration from a Stop
Service Category
Engine/Hybrid System
Section
Engine Control
Market
USA
Applicability
Introduction
Some 2010 - 2011 model year Sequoia vehicles with the 1UR-FE (4.6 L) engine may exhibit non-linear acceleration from a stop under certain conditions of low engine rpm with high engine load. The Engine Control Module/ECM (SAE term: Powertrain Control Module/PCM) logic has been revised to address this condition. Use the following repair procedure to recalibrate the ECM (PCM).
Warranty Information
APPLICABLE WARRANTY
^ This repair is covered under the Toyota Federal Emission Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first, from the vehicle's in-service date.
^ Warranty application is limited to occurrence of the specified condition described in this bulletin.
Parts Information
Calibration Information
Required Tools & Equipment
Repair Procedure
1. Confirm the condition matches the Introduction.
2. Check for the Authorized Modifications Label affixed to the vehicle in the location shown in Figure 1. Confirm if the ECM (PCM) calibration has been updated. If the calibration ID listed is NOT the latest ECM (PCM) calibration - go to step 3.
3. Flash reprogram the ECM (PCM).
NOTE
^ The GR8 Battery Diagnostic Station MUST be used in Power Supply Mode to maintain battery voltage at 13.5 volts while flash reprogramming the vehicle.
^ For details on how to use the GR8 Battery Diagnostic Station, refer to the located on the Technical Information System (TIS), Diagnostics - Battery
Follow the procedures outlined in TSB No. T-SB-0064-10, "Techstream ECU Flash Reprogramming Procedure� and flash the ECM (PCM) with the NEW calibration file update.
4. Install the Authorized Modifications Label.
A. Using a permanent marker enter the following information on the label:
^ ECM part number [Refer to the Parts Information section for the CURRENT PART NUMBER]
^ Calibration ID(s) [Refer to the Calibration Identification Chart for the NEW CALIBRATION ID]
^ Dealer Code
^ Repair Date
^ Change Authority [This TSB number]
B. Affix the Authorized Modifications Label to the vehicle at the location shown in Figure 1. The Authorized Modifications Label is available through the MDC P/N 00451-00001-LBL.
5. Test drive the vehicle to confirm proper vehicle operation.