Installation

1UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: INSTALLATION

1. INSTALL POWER STEERING OIL PRESSURE SWITCH

(a) Install a new O-ring to the power steering oil pressure switch.

(b) Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.

NOTICE:
* When reusing the power steering oil pressure switch, inspect the O-ring.
* If the O-ring has scratches or cuts, replace the power steering oil pressure switch.

(c) Using SST, install the power steering oil pressure switch.

SST : 09922-10010

without SST - Torque : 21 Nm (210 kgf-cm, 15 ft-lbf)

with SST - Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

HINT
* Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Service Precautions.
* Make sure SST and the torque wrench are connected in a straight line.





(d) Connect the oil pressure switch connector.

2. INSTALL FAN AND GENERATOR V BELT

(a) Install the fan and generator V belt Installation.

3. ADD POWER STEERING FLUID

4. BLEED POWER STEERING FLUID On-Vehicle Inspection

5. INSPECT FOR POWER STEERING FLUID LEAK

6. CHECK FLUID LEVEL On-Vehicle Inspection

7. INSTALL FRONT FENDER APRON SEAL RH Installation

8. INSTALL FRONT WHEEL Installation