Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND DECELERATION SENSOR: INSTALLATION

1. INSTALL YAW RATE SENSOR

(a) Connect the sensor connector (labeled A), and then attach the clamp (labeled B) to the hole of the sensor bracket.

(b) Install the yaw rate sensor with the 2 nuts (labeled C).

Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)

NOTICE:
* Make sure that the sensor is oriented correctly.
* If the sensor is dropped, replace it.
* Securely connect the connector.
* When installing the sensor, avoid impacts to the sensor.






2. INSTALL REAR CONSOLE BOX ASSEMBLY Installation

3. INSTALL CONSOLE BOX CARPET Installation

4. INSTALL REAR CONSOLE BOX POCKET Installation

5. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

8. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

(a) Perform the yaw rate sensor zero point calibration Programming and Relearning.

9. CHECK YAW RATE SENSOR SIGNAL

(a) Check the yaw rate sensor signal Test Mode Procedure.