Installation

EXTERIOR PANELS / TRIM: REAR BUMPER: INSTALLATION

1. INSTALL REAR BUMPER COVER

(a) Engage the 12 claws and install the rear bumper cover.

(b) Engage the 2 harness clamps and connect the connector.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Tighten the 2 bolts for lower side of the rear bumper cover.

Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

(e) Tighten the 2 screws and install the 2 clips.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

2. INSTALL REAR QUARTER PANEL MUDGUARD LH

(a) Install the rear quarter panel mudguard with the 9 screws and clip.

3. INSTALL REAR QUARTER PANEL MUDGUARD RH

HINT
Use the same procedure as for the LH side.