Programming and Relearning

SEAT: REAR POWER SEAT CONTROL SYSTEM: INITIALIZATION

1. INITIALIZATION PROCEDURE

NOTICE:
If the fold seat control ECU is replaced, the seat position becomes unstable and the power seat motor must be reset (pulse sensor position must be initialized). If reset is not performed, stowage operation, return operation, and jam protection do not function.

HINT
* Perform the initialization procedure after confirming that a seat position is not recorded in the fold seat control ECU (ECU is not initialized).
* If initialization has been completed, repeat initialization cannot be performed. If repeat initialization is necessary, perform the initialization release procedure before initialization.

(a) Press the fold seat switch in the fold position until the third-row seat is completely folded (stowed).

(b) With the third-row seat in the completely folded position (stored), hold the fold seat switch in the fold position for 1 more second.

(c) The buzzer sounds twice when the initialization is complete.

2. INITIALIZATION RELEASE PROCEDURE

HINT
* Perform the initialization release procedure after confirming that a seat position is recorded in the fold seat control ECU (ECU is initialized).
* Perform initialization release when the initialization needs to be cleared, such as when the fold seat control ECU (computer where the seat position is recorded) has been swapped left-to-right or with one from another vehicle for troubleshooting.

(a) While holding the fold seat switch in the return position, press the rear power seat switch in the forward position 5 times before 10 seconds elapse. This will complete the initialization release procedure.

NOTICE:
* If the fold seat switch is not held in the return position for more than 10 seconds, the initialization release will be cancelled.
* If the rear power seat switch is pressed 6 times before 10 seconds have elapsed with the fold seat switch held in the return position, the initialization release will be cancelled.