Instruments - Compass Calibration Procedure

T-SB-0152-10

June 17, 2010

Initial Calibration of Compass During PDS

Service Category
General

Section
Pre-Delivery Service

Market
USA





Applicability

Introduction





Some 2011 model Sequoia vehicles are equipped with a compass in the rear view mirror. In order for the compass to correctly indicate the direction that the vehicle is heading it must be calibrated prior to vehicle delivery. Use the following procedure to perform initial calibration during Pre-Delivery Service (PDS).





Warranty Information

Compass Calibration Procedure

1. Cycle the ignition switch to the "IG-ON" position.





2. Push and hold the "N" switch until the zone number appears on the compass display

NOTE

Pushing the "N" switch turns the compass display ON or OFF.





3. Push the "N" switch to select the number of the zone where the vehicle is located. See the map in Figure 3 for zone reference.





4. Once the correct zone is selected start the engine and push and hold the "N" switch until "CAL appears on the display.





5. Drive the vehicle slowly at 5 mph (8 km/h), or less, in a circle until the direction is displayed. If there is NOT enough space to drive in a circle, drive around the block until the direction is displayed.

Once the direction is displayed, the calibration is complete.

NOTE

^ Do NOT perform calibration of the compass in a place where the Earth's magnetic field is subject to interference (underground parking, under a steel tower, between buildings, roof parking, near a railroad crossing, near a large vehicle, etc.)

^ During calibration, do NOT operate electric systems (moon roof, power windows, etc.) as they may interfere with the calibration.