Wireless Door Lock Control System (w/ Smart Key System)

DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System): B1242: Wireless Door Lock Tuner Circuit Malfunction
B1242 - Wireless Door Lock Tuner Circuit Malfunction

DESCRIPTION

The door control receiver is used to receive electrical waves relating to the entry functions of the smart key system. The certification ECU (smart key ECU assembly) decodes the requested smart key system operation by identifying a key code based on the electric waves received via the door control receiver. The door control receiver receives a signal from the door control transmitter and sends signals to the main body ECU through the certification ECU (smart key ECU assembly). The certification ECU (smart key ECU assembly) then sends a command, according to the requested operation, to each ECU (ex. if door lock operation is requested, the certification ECU (smart key ECU assembly) sends a door lock command to the main body ECU).





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* When replacing or inspecting the door control receiver and wire harness, do not change the position or length of the wire harness. If the wire harness is too close to the door control receiver, entry and wireless function performance may be affected.
* Before performing the inspection, check that there are no problems related to the CAN communication system and LIN communication system.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - CERTIFICATION ECU AND BODY GROUND)

(a) Disconnect the D87 and D88 certification ECU (smart key ECU assembly) connectors.

(b) Disconnect the L27 door control receiver connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

(a) Reconnect the D87 and D88 certification ECU (smart key ECU assembly) connectors.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal
OK -- Continue to next step.

3. REPLACE DOOR CONTROL RECEIVER

(a) Temporarily replace the door control receiver with a new one Removal.

NEXT -- Continue to next step.

4. CHECK FOR DTC

(a) Clear the DTC Wireless Door Lock Control System (w/ Smart Key System).

(b) Recheck for DTCs.

OK:

DTC B1242 is not output.

NG -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal

OK -- END (DOOR CONTROL RECEIVER WAS DEFECTIVE)