B225E

DOOR / HATCH: SLIDE DOOR CLOSER SYSTEM: B225E: Power Slide Door Neutral Closer Switch RH Malfunction during Close Operation
B225E - Power Slide Door Neutral Closer Switch RH Malfunction during Close Operation

DESCRIPTION

The neutral position switch is installed to the power slide door lock assembly, and detects the neutral position of the active closer lever. During a slide door close operation, if the neutral position cannot be accurately detected due to a malfunction in either the neutral position switch (NPR) or neutral position switch (NPC) signal, the power slide door ECU stores a DTC.

CAUTION:
A malfunction in the neutral position switch may cause the power slide door to open unexpectedly, even when the vehicle is in motion.

HINT
After the close operation, the active closer lever returns to the neutral position area by means of the close return operation. During this operation, the neutral position SW (NPR) and neutral position SW (NPC) operate according to the following table.













WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM (POSITION SWITCH)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Rear Right Door / Data List.

(e) Read the Data List according to the display on the Techstream.

Rear Right Door





OK:

When the switch is operating, the Techstream should display as shown in the above table.

NG -- INSPECT POWER SLIDE DOOR LOCK ASSEMBLY RH

OK -- REPLACE SLIDE DOOR MOTOR UNIT RH (POWER SLIDE DOOR ECU RH) Disassembly

2. INSPECT POWER SLIDE DOOR LOCK ASSEMBLY RH

(a) Remove the Power slide door lock assembly RH.

(b) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





NG -- REPLACE POWER SLIDE DOOR LOCK ASSEMBLY RH Disassembly
OK -- Continue to next step.

3. CHECK REAR DOOR WIRE RH (POWER SLIDE DOOR LOCK ASSEMBLY RH - POWER SLIDE DOOR ECU RH)

(a) Disconnect the I9 power slide door ECU RH connector.

(b) Disconnect the I11 power slide door lock assembly RH connector.

(c) Measure the resistance according to the value(s) in the table below.





Text in Illustration





Standard Resistance:





NG -- REPAIR OR REPLACE REAR DOOR WIRE RH Disassembly

OK -- REPLACE SLIDE DOOR MOTOR UNIT RH (POWER SLIDE DOOR ECU RH) Disassembly