B2261

DOOR / HATCH: SLIDE DOOR CLOSER SYSTEM: B2261: Power Slide Door Neutral Closer Switch LH Malfunction during Open Operation
B2261 - Power Slide Door Neutral Closer Switch LH Malfunction during Open Operation

DESCRIPTION

Refer to DTC B2260 B2260.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM (POSITION SWITCH)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Rear Left Door / Data List.

(e) Read the Data List according to the display on the Techstream.

Rear Left Door





OK:

When the switch is operating, the Techstream should display as shown in the above table.

NG -- INSPECT POWER SLIDE DOOR LOCK ASSEMBLY LH

OK -- REPLACE SLIDE DOOR MOTOR UNIT LH (POWER SLIDE DOOR ECU LH) Disassembly

2. INSPECT POWER SLIDE DOOR LOCK ASSEMBLY LH

(a) Remove the Power slide door lock assembly LH.

(b) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





NG -- REPLACE POWER SLIDE DOOR LOCK ASSEMBLY LH Disassembly
OK -- Continue to next step.

3. CHECK REAR DOOR WIRE LH (POWER SLIDE DOOR LOCK ASSEMBLY LH - POWER SLIDE DOOR ECU LH)

(a) Disconnect the J8 power slide door ECU LH connector.

(b) Disconnect the J11 power slide door lock assembly LH connector.

(c) Measure the resistance according to the value(s) in the table below.





Text in Illustration





Standard Resistance:





NG -- REPAIR OR REPLACE REAR DOOR WIRE LH Disassembly

OK -- REPLACE SLIDE DOOR MOTOR UNIT LH (POWER SLIDE DOOR ECU LH) Disassembly