Engine Immobiliser System (w/ Smart Key System)

THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM (w/ Smart Key System): B2799: Engine Immobiliser System Malfunction
B2799 - Engine Immobiliser System Malfunction

DESCRIPTION

This DTC is stored when one of the following occurs: 1) the ECM detects an error in its own communication with the certification ECU; 2) the ECM detects an error in the communication lines; or 3) the ECU communication ID between the certification ECU and ECM is different when an engine start is attempted.

HINT
Before troubleshooting this DTC, make sure that no certification ECU DTCs are present. If present, troubleshoot the certification ECU DTCs first.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
If the certification ECU is replaced, register the key Engine Immobiliser System (w/ Smart Key System).

PROCEDURE

1. CHECK DTC OUTPUT

(a) Clear the DTCs Engine Immobiliser System (w/ Smart Key System).

(b) Recheck for DTCs Engine Immobiliser System (w/ Smart Key System).

OK:

DTC B2799 is not output.

NG -- RE-REGISTER ECU COMMUNICATION ID

OK -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting

2. RE-REGISTER ECU COMMUNICATION ID

(a) Re-register the ECU communication ID Engine Immobiliser System (w/ Smart Key System).

NEXT -- Continue to next step.

3. CHECK DTC OUTPUT

(a) Clear the DTCs Engine Immobiliser System (w/ Smart Key System).

(b) Recheck for DTCs Engine Immobiliser System (w/ Smart Key System).

OK:

DTC B2799 is not output.

NG -- CHECK CONNECTOR CONNECTION CONDITION

OK -- END (ECU COMMUNICATION ID WAS INCORRECT)

4. CHECK CONNECTOR CONNECTION CONDITION

(a) Turn the engine switch off.

(b) Check that the connectors are properly connected to the ECM and certification ECU.

OK:

Connectors are properly connected.

NG -- CONNECT CONNECTORS PROPERLY
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ECM)

(a) Disconnect the certification ECU connector.

(b) Disconnect the ECM connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. REPLACE ECM

(a) Replace the ECM Removal.

NEXT -- Continue to next step.

7. CHECK DTC OUTPUT

(a) Clear the DTCs Engine Immobiliser System (w/ Smart Key System).

(b) Recheck for DTCs Engine Immobiliser System (w/ Smart Key System).

OK:

DTC B2799 is not output.

NG -- REPLACE CERTIFICATION ECU Removal

OK -- END (ECM WAS DEFECTIVE)