Display Signal Circuit between Video Terminal and Television Display

AUDIO / VIDEO: REAR SEAT ENTERTAINMENT SYSTEM: Display Signal Circuit between Video Terminal and Television Display
- Display Signal Circuit between Video Terminal and Television Display

DESCRIPTION

This is the display signal circuit from the video terminal to the television display assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK TELEVISION DISPLAY ASSEMBLY

(a) Disconnect the U2 television display assembly connector.





(b) Using an oscilloscope, check the signal waveform between each terminal and the body ground according to the conditions, as shown in the chart below.

Signal Waveform (Reference)





OK:

Waveform is as shown in the illustration.

Text in Illustration





NG -- CHECK HARNESS AND CONNECTOR (VIDEO TERMINAL - TELEVISION DISPLAY)

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table

2. CHECK HARNESS AND CONNECTOR (VIDEO TERMINAL - TELEVISION DISPLAY)

(a) Disconnect the P3 video terminal connector.

(b) Disconnect the U2 television display assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE VIDEO TERMINAL Removal