Power Back Door Warning System Does Not Operate

DOOR / HATCH: POWER BACK DOOR SYSTEM: Power Back Door Warning System does not Operate
- Power Back Door Warning System does not Operate

DESCRIPTION

When the power back door warning system does not operate, one of the following may be malfunctioning: 1) power back door warning buzzer circuit, 2) wireless door lock control system or 3) power back door ECU.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* The power back door warning function can be customized. Make sure the function is on Customize Parameters.
* The power back door system uses a CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting How to Proceed With Troubleshooting. Troubleshoot the power back door system after confirming that the communication system is functioning properly.

PROCEDURE

1. CHECK OPERATION

(a) Check power back door system operation.

Result





C -- REPLACE POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT) Removal

B -- CHECK WIRELESS DOOR LOCK CONTROL SYSTEM (HAZARD ANSWER-BACK FUNCTION)
A -- Continue to next step.

2. PERFORM ACTIVE TEST USING TECHSTREAM (PBD BUZZER)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Back Door / Active Test.

(e) Using the Techstream, perform the Active Test to generate a control command, and check that the power back door warning buzzer sounds.

Back Door (Power Back Door ECU)





OK:

Buzzer sounds normally.

NG -- INSPECT POWER BACK DOOR WARNING BUZZER

OK -- REPLACE POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT) Removal

3. INSPECT POWER BACK DOOR WARNING BUZZER

(a) Remove the power back door warning buzzer Removal.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPLACE POWER BACK DOOR WARNING BUZZER Removal
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (POWER BACK DOOR WARNING BUZZER - POWER BACK DOOR ECU)

(a) Disconnect the W9 power back door warning buzzer connector and K14 power back door ECU connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT) Removal

5. CHECK WIRELESS DOOR LOCK CONTROL SYSTEM (HAZARD ANSWER-BACK FUNCTION)

(a) Check wireless door lock operation.

Result





B -- GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (NO ANSWER-BACK) Exterior Lighting System
A -- Continue to next step.

6. REPLACE POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT)

(a) Replace the power back door ECU (power back door motor unit) Removal.

NEXT -- Continue to next step.

7. CHECK POWER BACK DOOR OPERATION

(a) Check that the power back door hazard warning lights operate normally Operation Check.

OK:

The power back door hazard warning lights operate normally.

NG -- REPLACE MAIN BODY ECU Removal

OK -- END (POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT) WAS DEFECTIVE)