Canada - Body - Power Liftgate Initialization Procedure

Bulletin
TSB3366

Issue Date
March 09, 2010

Market
Canada

Title
INITIALIZATION OF POWER BACK DOOR DURING PDS

Component
GENERAL INFORMATION

Models
'11 Sienna

INTRODUCTION:
As a result of the removal of the Short Pin, the "automatic open and close" and "jam protection" functions of the power back door will be inoperative due to loss of the power back door position. Initialize the power back door after installing the Short Pin in its original location during Pre-Delivery Service (PDS).

NOTE:
- Any time the battery terminal has been disconnected, the power back door may need to be reinitialized.
- If the short pin is installed with the power sliding doors fully closed, the initialization may not be required because the power sliding door position memory is still stored in the microcomputer.

APPLICABLE VEHICLES:






WARRANTY INFORMATION:






Overview

INITIALIZATION PROCEDURE:
1. Fully close the power back door by hand, if open.







2. Check that the power back door will fully open and fully close.
A. Check that the power back door main switch is in the "ON" position.
B. Check that the back door will fully open and fully close by pushing the power back door satellite switch or PBD button briefly.

NOTE:
Jam protection function becomes effective through the above initialization procedure.