Installation

2GR-FE ENGINE CONTROL: AIR FUEL RATIO SENSOR: INSTALLATION

1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

(a) Using SST, install the air fuel ratio sensor to the exhaust manifold RH.

Text in Illustration

SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

HINT
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
* The torque value is effective when SST is parallel to the torque wrench.

2. INSTALL EXHAUST MANIFOLD TO HEAD GASKET Installation

3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH Installation

4. INSTALL MANIFOLD STAY Installation

5. INSTALL FRONT EXHAUST PIPE ASSEMBLY (for 2WD) Installation

6. INSTALL FRONT EXHAUST PIPE ASSEMBLY (for AWD) Installation

7. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET Installation

8. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for AWD)

Installation

9. INSTALL NO. 2 ENGINE UNDER COVER (for AWD) Installation

10. INSTALL NO. 1 ENGINE UNDER COVER Installation

11. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

(a) Using SST, install the air fuel ratio sensor to the exhaust manifold LH.

Text in Illustration