Installation
2GR-FE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION
1. INSTALL NO. 2 OXYGEN SENSOR (for Bank 1 Sensor 2)
(a) Using SST, install the No. 2 oxygen sensor to the front exhaust pipe assembly.
Text in Illustration
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
HINT
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
* The torque value is effective when SST is parallel to the torque wrench.
2. INSTALL OXYGEN SENSOR (for Bank 2 Sensor 2)
(a) Using SST, install the oxygen sensor to the center exhaust pipe assembly.
Text in Illustration
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
HINT
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
* The torque value is effective when SST is parallel to the torque wrench.
3. INSTALL FRONT EXHAUST PIPE ASSEMBLY (for 2WD) Installation
4. INSTALL FRONT EXHAUST PIPE ASSEMBLY (for AWD) Installation
5. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET Installation
6. INSTALL NO. 2 ENGINE UNDER COVER (for AWD) Installation
7. INSTALL NO. 1 ENGINE UNDER COVER Installation
8. INSPECT FOR EXHAUST GAS LEAK
9. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation