Installation

LIGHTING (EXT): HAZARD WARNING SWITCH: INSTALLATION

1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY

(a) Engage the 2 claws and install the hazard warning signal switch.

2. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL Installation

3. INSTALL INSTRUMENT PANEL FINISH PANEL Installation

4. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Installation

5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

6. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

7. ADJUST SPIRAL CABLE Installation

8. INSTALL STEERING WHEEL ASSEMBLY Installation

9. INSPECT STEERING WHEEL CENTER POINT

10. INSTALL STEERING PAD Installation

11. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

12. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

13. POSITION FRONT WHEELS FACING STRAIGHT AHEAD

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

15. INSPECT STEERING PAD Steering Pad

16. INSPECT SRS WARNING LIGHT

Diagnosis System