Installation

FRONT SUSPENSION: FRONT STABILIZER BAR (for AWD): INSTALLATION

1. INSTALL FRONT STABILIZER BAR

(a) Install the front stabilizer bar from the left side of the vehicle.

2. INSTALL FRONT NO. 1 STABILIZER BAR BUSHING

(a) Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.





Text in Illustration





NOTICE:
When installing the front No. 1 stabilizer bar bushings, make sure that the cutout faces the rear of the vehicle.

3. INSTALL FRONT NO. 2 STABILIZER BRACKET LH

(a) Install the front No. 2 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.

4. INSTALL FRONT NO. 2 STABILIZER BRACKET RH

HINT
Perform the same procedure as the LH side.

5. INSTALL FRONT NO. 1 STABILIZER BRACKET LH

(a) Install the front No. 1 stabilizer bracket LH to the front frame assembly with the 2 bolts.

Torque : 30 Nm (306 kgf-cm, 22 ft-lbf)

6. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT
Perform the same procedure as the LH side.

7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

(a) Install the front stabilizer link assembly LH with the 2 nuts.

Torque : 74 Nm (755 kgf-cm, 55 ft-lbf)

HINT
If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

8. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT
Perform the same procedure as the LH side.

9. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

10. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET Installation

11. INSTALL EXHAUST MANIFOLD TO HEAD GASKET

Installation

12. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

Installation