Body - Power Liftgate Initialization Procedure

T-SB-0013-10

January 19, 2010

Initialization of Power Back Door During PDS

Service Category
General

Section
Pre-Delivery Service

Market
USA





Applicability

Introduction

As a result of the removal of the Short Pin, the "automatic open and close" and "jam protection" functions of the power back door will be inoperative due to loss of the power back door position.

Initialize the power back door after installing the Short Pin in its original location during Pre-Delivery Service (PDS).

NOTE

^ Any time the battery terminal has been disconnected, the power back door may need to be re-initialized.

^ If the short pin is installed with the power sliding doors fully closed, the initialization may not be required because the power sliding door position memory is still stored in the microcomputer.





Warranty Information





Overview

Initialization Procedure

1. Fully close the power back door by hand if open.





2. Check that the power back door will fully open and fully close.

A. Check that the power back door main switch is in the "ON" position.

B. Check that the back door will fully open and fully close by pushing the power back door satellite switch or PBD button briefly.

NOTE

Jam protection function becomes enabled through the above initialization procedure.