Canada - Rear View Monitor System - Initialization Procedure

Bulletin
TSB3368

Issue Date
March 09, 2010

Market
Canada

Title
INITIALIZATION OF REAR VIEW MONITOR SYSTEM

Component
GENERAL INFORMATION

Models
'11 Sienna

INTRODUCTION:
As a result of the removal of the short pin, the power source to the steering angle sensor is cut off. When the short pin is reinstalled, the rear view monitor system will be operative, but it cannot display "guide lines to assist parking operation because the center position is not recognized by the steering angle sensor. Please initialize the rear view monitor system after installing the short pin during PDS (Pre-delivery Service).

NOTE:
Any time the battery terminal has been disconnected, the rear view monitor system MUST be reinitialized.






APPLICABILITY:






WARRANTY INFORMATION:

INITIALIZATION PROCEDURE:
1. Start the engine and check if the rear view monitor system is operative.







A. Shift the shift lever to the "R" (reverse) position. If the rear view monitor appears as illustrated in Figure 1, please initialize the rear view monitor system.

2. Shift the shift lever to the "P" (park) position. Turn the steering wheel lock to lock.







3. Shift the shift lever to the "R" (reverse) position and touch the parallel parking mode switch on the screen. When the longitudinal guidelines and "Check surroundings for safety" appear on the rear view monitor as illustrated in Figure 2, the initialization of the parking assist monitor has been completed.