Disassembly: RH Side

1. Place the seatback in the upright position prior to disassembly. If seatback will not lock into place, some steps will require another person to hold the seatback upright in order to properly disassemble.





2. Remove the rear No. 2 seat cover bezel. Figure 20.

A. Remove the 2 screws.

B. Disengage the 2 guides and remove the 2 rear No. 2 seat cover bezels.





3. Remove the rear seatback lock striker cover.

Using a plastic pry tool, disengage the 3 claws and remove the rear seatback lock striker cover.

4. Remove the third seat handle.

A. Remove the 2 screws.

B. Disengage the 3 guides and separate the third seat handle.

C. Disconnect the 4 cable clamps and remove the third seat handle.





5. Remove the rear seatback lock control bezel.

A. Remove the screw.

B. Disengage the guide and remove the rear seatback lock control bezel.

6. Remove the rear No. 2 seat reclining cover LH.





A. Disengage the 7 clips and remove the rear seatback board cover RH.





B. Remove the 2 screws.

C. Disengage the 2 guides and remove the rear No. 2 seat reclining cover LH.





7. Remove the rear No. 2 seat reclining cover RH. Figure 27.

A. Remove the 2 screws.

B. Disengage the 2 guides and remove the rear No. 2 seat reclining cover RH.





8. Remove the bolt and the rear No. 2 seat inner belt assembly RH.

9. Remove the No. 2 seat headrest assembly.





A. Remove the 8 hog rings and 2 clips.





B. Remove the 3 hog rings.





C. Remove the clip and pass the No. 2 seat reclining release handle sub-assembly through the No. 2 seatback cover with pad RH.





D. Using a screwdriver with its tip wrapped in protective tape, release the lock inside the headrest support and remove the No. 2 seat headrest assembly.





10. Remove the rear No. 2 seat headrest support assembly.

Disengage the 4 claws and remove the 2 rear No. 2 seat headrest support assemblies.





11. Remove the No. 2 seatback cover with pad RH.





12. Remove the No. 2 seatback frame sub-assembly RH.

A. Disconnect the 3 cable clamps and separate the 2 reclining remote control cable assemblies.





B. Remove the 4 bolts and No. 2 seatback frame sub-assembly RH.