Power Slide Door ECU LH Power Source Circuit

DOOR / HATCH: POWER SLIDE DOOR SYSTEM: Power Slide Door ECU LH Power Source Circuit
- Power Slide Door ECU LH Power Source Circuit

DESCRIPTION

This circuit provides power to operate the slide door motor unit LH (power slide door ECU LH).

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (ECU LH - BATTERY AND BODY GROUND)

(a) Disconnect the J9 power slide door ECU LH connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Power Slide Door System